SVA Cover Set 1•4
1.9
16
Repeat the process for the other side of
the car.
2
Fog & Reverse Lights
1
Locate from your parts two aluminium
leveling brackets[I].
2
Cover the edges of the brackets in small
U section trim [G].
3
Remove the fog and reverse lamps if
fitted.
4
Reposition the lamps with the bracket
behind the lamp with the fold in the
aluminium at the top of the lamp (Fig
2.1).
2.1
5
Locate the U section tubing [G] from
your parts.
6
Position the tubing round the edge of
the outer plastic case of the reverse and
fog lamps (Fig 2.2).
2.2
3
Windscreen posts
NOTE:
Where the side screens locate on the A
posts, require covers fitting to meet external
projection requirements.
1
Locate the four A post covers [K] from
your parts.
2
Push the covers over the lugs on the A
post covers (Fig 3.1).
3.1
3
Repeat the process for the other three
lugs.
4
Harness Buckle Covers
NOTE:
The buckle covers require 15mm cutting off
the pointed end so they can slide over the
eyelet.
1
Locate from your parts the four harness
buckle covers.
2
If necessary remove the buckles from
the eyelets.
3
Push the small end of the cover over the
eyelet, turning it inside out as you do so
(Fig 4.1).
4.1
4
Reconnect the buckle, pull the cover
over the buckle (Fig 4.2).
4.2
5
Repeat the process for the other three
buckles.
5
Rear Number Plate
1
Locate some U section tube [G] from
your parts.
2
Fit the tubing to the rear edge of the
number plate surround (Fig 5.1).
5.1
6
Hood Mounting Covers
1
Locate from your parts the two brown
rubber covers [M].
2
Push the covers over the brackets fitted
to the chassis for fitting the hood (Fig
6.1).
6.1
3
Repeat the process for the other side.
