Revision 38
Chapter 10
Rollcage
Contents
INTRODUCTION .............................................................. 1
Tools Required ................................................................ 1
Standard Parts ................................................................ 1
Parts Required ................................................................ 2
FITTING OF ROLLCAGE .................................................... 3
1
Preparation – Body Sides ..................................... 3
2
Positioning – Rollcage .......................................... 3
3
Fitting – Rear Steadies ......................................... 3
4
Fitment – Final .................................................... 4
INTRODUCTION
The roll cage is a FIA approved racing cage. It is bolted to the chassis at 18 points with high grade M10 bolts. It is bolted directly to the top of
the rear bulkhead and to the side of the chassis through spacer tubes to clear the body work. The cage is also fitted to the lower rear chassis
via adjustable rose joints to ease fitting.
Tools Required
A.
5mm Drill Bit
B.
11mm Drill Bit
C.
Marking Tools
D.
Masking Tape
E.
17mm Socket x2
F.
5/8” Socket x2
G.
Touque Wrench
H.
Ratchet
Standard Parts
A.
M10 x 90mm Set Screw
x4
B.
M10 x 75 Set Screw
x4
C.
M10 x 25 Set Screw
x8
D.
7/16” x 2 ½” Set Screw
x2
E.
M10 Nylocs
x16
F.
7/16” Nylocs
x2
