User Guide
3. Management
3.2 Part Replacement
Figure 207:
Cable Retention Clip Operation
b.
Slide the retention clip forward on the PSUs until it stops near the cable connectors. Doing
this will ensure that the retention clips function properly in the event the cable is pulled on.
3.2.3
BMC Module Replacement
Table 34:
Replacement Procedure Info
Required Tools
# of People Required
Time Required
None
1
2 minutes
Step 1 :
Unpack and inspect the new BMC Module for damage.
a.
Inspect the packaging that the BMC Module replacement was shipped in and record any
damage to the box. Large cuts, open boxes, and crushed corners should be reported.
b.
Remove the BMC Module from the packaging and verify that there is no damage to the
BMC Module. Dents, scratches, and broken parts should be reported. If major damage has
occurred to the BMC Module, DO NOT use the replacement part.
c.
Store in a safe location until the BMC Module is needed for installation.
Step 2 :
Remove the BMC Module from the enclosure.
a.
From the front of the rack, grasp the release handle with your forefinger on the bottom and
thumb on the top. Press the release latch downward with your thumb. The handle will eject
from the front of the module:
120
