User Guide
3. Management
3.1 OCGUI
Step 9 :
Review the listed paths to identify the one referencing the previously selected volume and
host(s); the volume and host NQNs will be listed under the
Volume NQN
and
Host NQN
columns.
3.1.6.16
Configuring a Path to a VLAN
This task provides instructions for configuring a path between a volume and a VLAN on an F3x00 storage
device using the OCGUI.
Before you begin:
Note:
A path is a dedicated line of communication, which cannot be established until both
the volume and VLAN have been created.
Note:
The following instructions define how to create a path to a VLAN through the storage
device's
Volumes
page. That same path may also be created from the other direction—to a
volume through the device's
VLANs
page.
Step 1 :
Navigate to the storage device (see
Step 2 :
Click the storage device's
Volumes
icon:
The
Volumes
information appears:
Step 3 :
From the list of available volumes, identify the one that will be used to create the path.
The volume must be configured to allow any host, or a path cannot be established between
it and a VLAN. If the volume is incorrectly configured, it will be indicated by the following:
•
The
Allow Any Host
setting will be toggled to the
OFF
(disabled) position:
93
