250050 R1
119
6.38. Remote Roof Cap Opener Installation
6.38.1 Remote Roof Cap Opener System for 24' and 27'
(Standard for 7 — 9 tier bins)
Figure 88.
Roof Cap, Pivot Arms and Bracket Detail
8
1
11
16
6
4
2
10
15
26
7
9
27
12
10
29
10
REMOTE ROOF CAP OPENER INSTALLATION 15’ TO 27’
1. Bolt the pivot arm brackets (3) to the peak ring. (The brackets are interchangeable, right to left.)
2. Install the peak ring gasket (26) to the peak ring and trim to fit.
3. Slide two 5/16" eye-bolts (7) onto the pivot arm (2) and insert the end of the pivot arm through the spring
bracket and push nut (21).
4. Clip the ends of the springs onto the pivot arm. (Lower the pivot arm down into the roof to make this
easier.)
5. Bolt the rope arm (1) to the cap using a 5/16" x 3/4" bolt.
a. Bolt the rope arm bracket (27) to the cap with a 3/8" eye-bolt (10) and fasten the bracket to the rope
arm.
b. Do not tighten the rod eye-bolt.
6. Pull the pivot arm up and insert a 2x4 across the peak ring and under the pivot arm.
7. Attach a nut to each pivot arm eye-bolt.
a. Make sure the nuts are threaded down to the end of the thread.
b. Place a cap over the eye-bolts and tighten the nuts on top.
EASYDRY® WIDE-CORR CENTURION® GRAIN BIN – GRAIN BIN DRYER
