Wesmar SS590 SERIES, Installation & Operation Manual

Page: 26 / 62

INSTALLATION AND OPERATION
WESMAR
Page II- 16
Tighten the top hoist clamp.
Place the safety clamp immediately below the
hoist clamp and fasten it with the locking bolt.
We discuss positioning the tube in 4.0
Positioning the Soundome.
Place the neoprene gasket on the seachest
flange.
Lower the soundome into the seachest.
Position the hoist assembly so that you can
easily reach the Junction Box.
Use the bolts provided to secure the hoist flange
to the seachest.
NOTE: It may be necessary to file down the
fins of the soundome so that it fits into
the seachest. The clearance around
the soundome should not be greater
than 1.6mm (1/16 inch).
4.0 POSITIONING THE
SOUNDOME
To determine how high or low to position the
soundome tube within the seachest, go below
the boat and measure the distance between the
bottom of the soundome boot and the base of
the seachest.
The correct position of the soundome boot
is 3.8cm (1.5inches) within the seachest.
If the soundome is too high or too low, go back
to the hoist assembly,
Loosen the top hoist clamp and safety clamp.
Raise or lower the soundome according to your
measurement.
Align the soundome so that the mark you made
on the soundome tube points forward for the 6-
inch soundome.
After positioning the soundome tube, tighten
the top hoist clamp and the safety clamp.