Connecting the grease collecting canister (ConvoGrill)
1.
Check the accessories for damage, and only continue with the installation if all
the parts are intact and leak-tight.
2.
Plug the bare end of the connecting tube (2) of the automatic grease collecting
system onto the outlet pipe (1) at the back underneath the combi oven, and
secure the tube (2) with the hose clip (3).
3.
Screw the canister screw-cap (4) attached to the connecting tube (2) onto the
grease collecting canister (5).
4.
Place the grease collecting canister (5) in a suitable position and make sure
there are no kinks in the connecting tube (2).
5.
Fix the forked bracket (6) within reach of the outlet pipe (1). This bracket will
be used to hold the canister screw-cap (4) and connecting tube. To fix in
place, use the double-sided adhesive tape on the back of the bracket or the
pre-drilled holes in the bracket.
For appliances with a disappearing door:
Do NOT position the bracket (6) on that side of the combi oven alongside
which the appliance door slides back.
Installation position for the grease collecting canister
Install the grease collecting canister in accordance with the following requirements:
■
The canister must be positioned upright and with easy access beside the appliance on a flat surface.
■
The surface on which the canister sits must not lie more than 15 cm above the surface supporting the appliance.
■
The user's work area must not be obstructed.
6 Installation
Installation manual
60
