Weber Geset 100, Original User Manual

Page: 9 / 77

Chapter 1
General information
32708885 Geset 100
Version: 16.07.13 Page 9 of 77 GB
Explanation of the terms used
Term Explanation
3-Roll System
Is used for labeling around of round products.
Actuator
Drive for rotating or linear movements. Normally pneumatic
(cylinder) or electromagnetic (motors).
Air assist tube
The air assist tube conducts the
supporting air
through one
or more holes to the bottom of the label. It is attached next
to the peeler bar and can be adjusted.
Air assist
A jet of air that, when the label is being fed, presses the
label against the bottom of the tamp until it is held by the
vacuum.
Air Blast)
Air that blows on the label through holes in the tamp pad at
the time of labeling (through house nozzles when there is a
blow box) so that the label is placed on the product without
being touched.
Application cycle
Complete operating sequence of the labeling system (such
as printing the label, peeling it off, transferring it to the ap-
plicator and labeling the product).
Application mode
Depending on labeler’s equipment, different application
modes can be applied. See explanations: Tamp on, tamp
blow, blow on and wipe on.
Automatic mode
See labeling operation
Base conveyor
See also “conveying system”. The base conveyor trans-
ports the products that should be labeled.
Blow-on
Contact-less application mode in which the tamp receives
the printed label by a vacuum and blows it onto the product
without the tamp moving.
Conveying system
The unit consisting of the conveyor belt and its control
Conveyor
Belt for conveying the product
CS
Abbreviation for conveying system (see above)
Dancer arm
The arm that holds the label liner taught by spring tension.
Default
All basis settings for the system after it is made that can
differ from the status after the system is started up. The
software parameters can be returned to the defaults by be-
ing reset, and any changed values are lost.
Default
See factory-setting.
Gimbal adjustment
The gimbal adjustment is used to align the longitudinal and
lateral inclination of the labeling system and thus the peeler
bar to product. The peeler blade has to be aligned parallel
to product.
HMI
Abbreviation for Human-Machine-Interface, input unit for a
labeling system or a controller of components.
Home position
Basic position of the tamp at the peeler bar
Hotline
Customer support for a fast diagnosis by phone.