Chapter 8
Operation
32708885 Geset 100
Version: 16.07.13
Page 57 of 77
GB
Stop labeling operation
Requirements
¥
Labeling station is in labeling operation (s.a.)
Instruction
Please stop labeling operation as follows.
Step
Procedure
1
If possible, the labeling system should be run empty.
2
Push the [AUTOMATIC OFF] –button at operator panel to stop automatic
labeling operation.
3
Push the [STOP] –button at labeler.
4
Remove all products.
5
Observe the notes „Putting the system out of service“ (s. page 57)
Putting the system out of service
When turning off the system for several hours, the label web
must be removed from the applicator to avoid failures at re-
start.
The label material running around the deflection rollers is curved which can cause prob-
lems with the operation mode. This characteristic of the labels as well as the retained cur-
vature depend on the material which can vary significantly between the different print me-
dia. The ambient conditions such as high temperatures and humidity enhance this effect.
Remove critical label material before long breaks and after end of work from labe-
ler!
Instruction
Please put the label system out of service as follows.
Step
Procedure
1
Turn on and off labeling machine (s. page 55)
2
Stop labeling operation (s. page 57)
3
Disconnect the power supply.
4
Protect the labeling station if applicable from dust with a cotton or linen cloth.
5
If the labeling station should be stored and/or transported, please observe
the notes referring…
•
Transport (Page 28)
•
Storage conditions (Page 31)
6
Transport the labeling station like described in chapter “Transport“ to its
storage location.
Summary of Contents for Geset 100
Page 2: ...Blank page ...