8
Installation/Setup
Z-Wave
®
Network Setup
Use the following procedure to setup your
Z-Wave
®
network with the Wayne-Dalton USB
Z-Wave
®
Adapter as your primary controller.
Setting up your network refers to assigning
Z-Wave
®
modules to the USB Z-Wave
®
Adapter’s network. All modules must be
assigned to the Z-Wave
®
USB Adapter’s
network before any configuration or control
functions can be accomplished.
Note:
Devices, such as lamps and appliances,
should be plugged into a Z-Wave
®
module
before adding them to the network.
Note:
If you are adding the Z-Wave
®
USB
Adapter to an existing network, please see the
section titled “Joining Houseport
®
to an existing
Network” on page 23.
Houseport
®
can either be in
Design
or
Control
operation. For this section on network setup
make sure that Houseport
®
is set for
Design
operation.
Design
operation is indicated
when the window is outlined in a yellow and
black construction tape border.
