34
Resetting Z-Wave
®
Network
Use the following procedure to reset your
USB Z-Wave
®
Adapter to factory conditions.
WARNING: If your USB Z-Wave
®
Adapter
and Houseport
®
software are the Primary
Controller in a network, and you reset your
USB Z-Wave
®
Adapter, you will no longer
be able to add or remove modules from
your network without recreating the entire
network.
To reset the USB Z-Wave® Adapter:
1. To reset the Z-Wave
®
USB adapter select
the Reset Network item from the Network
menu. The confirmation window to the right will
appear.
Click on the ok button to proceed. All modules,
scenes, schedules and other network
information will be removed from the Z-Wave
®
USB adapter and Houseport. You are then ready
to start building up your Z-Wave
®
network
again.
NoTe:
If the USB Z-Wave
®
adapter is serving
as a secondary controller, remove it from the
network by clicking the ReCeIVe UPDATe FRoM
PRIMARY CoNTRoLLeR link and instructing the
Primary Controller to remove the USB Z-Wave
®
adapter. This may be referred to as ReMoVe
DeVICe, ReMoVe CoNTRoLLeR, eXCLUDe
DeVICe, or eXCLUDe CoNTRoLLeR.
NoTe:
If you reset your Primary Controller
before removing all the Z-Wave
®
modules
from your network, you must reset each of the
modules (see “Removing modules from the
network”, page 15) before adding modules to
the network again.
Factor
y Reset
