Redundancy Controller
Page
24
Document Number: 90-005-0030_E
General Purpose Output Settings [DISC OUT]
Use this menu to set (5 V) or clear (0V) the external outputs on the J2 connector.
Wavestream
Non-Wavestream
In0
No Connect or External Fault A
Amplifier A Status[High = Fault, Low = Ok]
In1
No Connect or External Fault B
Amplifier B Status[High = Fault, Low = Ok]
In2
General Input 2
General Input 2
In3
General Input 3
General Input 3
Out0
No Connect
Amplifier A Inhibit
Out1
No Connect
Amplifier B Inhibit
Out2
General Output 2
General Output 2
Out3
General Output 3
General Output 3
For non-Wavestream SSPAs these pins must be connected and set to mute the unit during
transition. Wavestream units are automatically muted when the baseball switch transitions from
one SSPA to another.
Go to
for information to add a transmit inhibit switch to the RMC.
Example:
1.
From the Home position select the SSPA. Press
Enter
.
2.
Select
DISC.OUT
and press
Enter
.
3.
Select
Clear
(0 V) or
Set
(5 V). For this example select
Set
.
4.
Press the right arrow on the front of the RMC.
5.
You should see OUTPUT 1. Select
Set
.
6.
Press the
Home
button to return to the SSPA-A home menu and
select
Save Unit Settings
.
7.
Repeat steps 1-6 for SSPA-B, select Clear or Set as appropriate.