WattMaster Water Source Heat Pump, Installation & Operation Manual

Page: 59 / 126

WattMaster WHP Section 3
Programming 3-11
New Passcodes
Programming Passcodes
The System Manager has two levels of passcode.
Level 1 users are limited to viewing Setpoints and Alarms only.
Level 2 users have complete system access. Any status or
setpoint field can be read or reset from WHP System Manager.
The default passcode is “1111” for level 1 and “2222” for level
2. If you need to change these defaults you can enter any 4 digit
number between 1000 and 9999.
If you “forget” the passcode you programmed, you can still
access the system with a built in backdoor code. This backdoor
code is “9288” and is not programmable. It is not recommended
that you give out this backdoor code since it would allow the
user access without regard to the standard programmable
passcode that most operators should be using.
The actual digits in your passcodes are never displayed. An "X"
is used as a place holder for each digit entered. Passcodes must
always be four digits in length.
Enter New Passcode
Level 1....: XXXX
Level 2....: XXXX
[Must Be 4 Digits]