Replace blown fuses with fuses of the proper type and rating as indicated on the rear panel and
as noted in the list of accessories and spares. The fuse holder is integrated in the mains
connector. Ensure that the instrument is never put in operation with fuses of a different type. This
could cause fire.
Note:
Only use manufacturer-supplied I/O cables to connect with other devices.
Thoroughly connect shielding to common. Manufacturer will not accept any liability for damage,
direct or indirect, caused by connecting this instrument to devices and with cables that do not
meet relevant safety standards. Place the detector on a flat, smooth surface. Do not block the
ventilation holes located at the bottom and lower rear panel of the detector. Blocking these holes
may impair the cooling capability of the power supply.
Solvents
The solvents used may be flammable, toxic, or corrosive. To prevent injury:
• Do not use an open flame near the device.
• Do not install the system in the same room with other equipment that emits or could
potentially emit sparks.
• Provide protective equipment near the instrument.
• When solvent gets into the eyes or on the skin, flush it away immediately.
• Provide equipment, such eye wash stations and safety showers, as close to the system as
possible.
• Use proper eye and skin protection when working with solvents.
• Seal sample containers (vials) to minimize any risks related to solvent vapor.
December 16, 2021, 715007395 Ver. 00
Page ix
