WATERS CORPORATION 2424, Operator'S Manual, Page: 54 / 196

2-24 Setting up the Detector
MassLynx system connections
Making inject start signal connections
When you are using an Ethernet data system with the detector, the data
system or controller must receive an inject-start signal from the autosampler
or manual injector to initiate the data collection and time-based programs.
The following table summarizes the inject start connections for different
system configurations.
Tip:
For pinout connections to the detector, see page 2-26 .
Detector inject start connections
Inject start output source
Inject start input connection (on the
2424 ELS detector, connector II)
Waters 700-series Inject Start In + / –
Waters Alliance Separations Module Inject Start In
Waters 712 Autosampler
Inject Start In + / –
Waters manual injector, or
third-party manual injector or
autosampler
Inject Start In + / –
TP02075
Chromatography
manager
Instrument LAN
network card
PDA detector
Mass
spectrometer
IEEE-488 cable
IEEE card
HPLC pump
IEEE-488
cable
Network switch
ELS detector