WATERS CORPORATION 2424, Operator'S Manual, Page: 50 / 196

2-20 Setting up the Detector
2. Insert one end of the inlet tubing assembly into the fluid fitting on the
front of the nebulizer.
Sample inlet tubing connection
3. Tighten the compression screw 1/4-turn past finger tight.
4. Repeat step 2, inserting the other end of the inlet tubing assembly into
the outlet fitting of the column or another detector.
Making signal connections
Tip:
Connect the detector to other HPLC system components through an
Ethernet connection.
The figure on
page 2-6 shows the rear panel locations of the connectors used to
operate the detector with external devices.
The signal connections you need to make to your detector depend on the signal
connections available on the other instruments in your HPLC system.
The following figure provides an overview of the steps to follow to connect the
detector to other instruments in your HPLC system.
Compression screw
Sample inlet tubing