CHAPTER 10: Field Definitions
186
WatchGuard Firebox System
Advanced
Click to access the Advanced Dynamic NAT dialog box.
Edit Routing Policy dialog box
Local
Select whether the local end of the policy represents either a single
host or an entire network. Then enter the host or network IP
address.
Remote
Select whether the remote end of the policy represents either a
single host or an entire network. Then enter the host or network IP
address.
Disposition
Select the disposition from the drop list.
Block: IPSec will not allow traffic that matches the rule in
associated tunnel policies. You cannot bypass a policy that has a
network at the other end point.
Bypass: IPSec will not allow traffic that matches the rule in
associated tunnel policies. You cannot bypass a policy that has a
network at the other end point.
Secure: IPSec will encrypt all traffice that matches the rule in
associated tunnel policies.
Tunnel
Select the tunnel from the drop down list.
OK
Closes this dialog box and saves any changes.
Cancel
Closes this dialog box without saving any changes.
More or Less
Click to enable or disable the advanced routing policy
configuration options-Dst Port, Protocol, and Src Port
Summary of Contents for Firebox X1000
