Doc. P/N:
WSP-009-008
Version: V1.3
Issue Date: April 2014
Operator Manual
System Configuration
47
Figure 27. Tooltips example
Cursor
Tooltip
►
Triple Beam Layout
:
The Triple Beam display can be set to a
horizontal
or
vertical
arrangement, depending on the
user’s preference.
►
Backscatter
:
Backscatter has been improved in WMB-X230 v1.2. To take advantage of improved backscatter
in WMB-X230 v1.2, the Backscatter setting must be changed to v1.2. Following this, a short patch
test is required in order to calibrate your system’s backscatter. See section “8.2.9.1 Backscatter
(v1.2 and later)” on page 57 of the Installation Manual.
►
Enable Tooltips
:
Tooltips can be enabled/disabled with this checkbox.
When enabled, positioning the cursor over buttons
on the Main Menu and the Utility Panel will reveal the
operation of that button.
►
Triple Beam Scale:
By default, the data displayed on the port and starboard beams are not scaled, and thus display
Range
information. If depth information is preferred, setting the Triple Beam Scale to
Depth
will
scale the data accordingly.
►
Depth Scale for SB/TB
:
The location of the depth scale overlay can be switched from the left-hand side (default) to the
right-hand side with this option.
►
Gain Control
:
When Gain Control is set to
Global
(default), the gain control dial (see “Gain Control” on page
7) controls the visual gain for the sonar and single / triple beam displays simultaneously. If
set to
Active Display
, the gain dial will affect only the display with the yellow border (the active
display).
