890405_d•en•2015-12-01
We reserve the right to carry out improvements
31
Current settings of the parameters shown to the left
This display only appears in the parameter menus. The function buttons to
the right of values that cannot or may not be changed are not active.
Cursor line
The coloured cursor line indicates which menu line is currently selected. The
arrow buttons on the left can be used to move the cursor line up or down.
Press
ok
to activate the selected menu line.
Right function button field
This grey field shows the functions of the buttons next to it. The buttons can
have different functions depending on the menu and the selected menu line.
The function buttons on the right side are primarily used to operate products,
activate functions and enter parameters.
6.1.1 Status display
The symbols in the header indicate the following states of the WMS:
Charge status
(green symbol)
The number of segments indicates the charge status. The segments are
switched on and off during charging (
)
Low charge status
(red symbol)
Place the WMS Central transmitter into the charging station for charging
soon.
Batteries nearly depleted
(red symbol)
Place the WMS Central transmitter into the charging station for charging.
Bad batteries
(red symbol)
The batteries are faulty or too old. Replace the batteries with new original re-
chargeable batteries.
NOTE
If you have commercially-available batteries in the device and place the de-
vice into the charging station, this symbol appears after some minutes. The
charging controller has detected the batteries and stopped charging. When
operating the device with regular batteries, you do not need to put it into the
charging station. We recommend using the supplied rechargeable batteries
because regular batteries have a short life.
No batteries inserted
Insert the supplied batteries into the device (
see Chapter 3.3 on page 14
).
Dealer mode
This symbol appears while you are logged in as the specialist dealer.
Transmission active
This symbol is displayed while the central transmitter is executing a transmis-
sion.
Green symbol: The central transmitter is transmitting.
Red symbol: The central transmitter did not receive a response from the
receiver.
Netting started