890405_d•en•2015-12-01
We reserve the right to carry out improvements
13
Position the charging station on a level surface close to a power socket. The
power supply unit cable should not be taut. Ensure that no one can trip on
the cable.
Do not erect the unit outdoors, close to heat sources (heater, fireplace, etc.)
or in direct sunlight.
Plug the external power supply unit into a power socket.
The charging station is now ready for operation.
CAAUIOA
The plastic feet of the device may leave marks on sensitive surface such
as on furniture. Modern furniture is coated with a variety of surface finishes
that can be treated with a selection of care products. Some of these agents
may contain substances that corrode or soften the plastic feet of the device.
Plastic feet that have been damaged in this way may leave marks on
furniture. Use a non-slip mat to prevent surface damage.
3.2.2 Charging station as a wall
support
If you wish to install the charging station on the wall, it is not necessary to at-
tach the base to the charging station.
Use the included screws and dowels to install the charging station on a flat,
vertical surface.
The following points must be observed:
Select an installation location close to a power socket. The power supply unit
cable should not be taut. Ensure that no one can trip on the cable.
Do not erect the unit outdoors, close to heat sources (heater, fireplace, etc.)
or in direct sunlight.
Choose an installation height that permits convenient reading of the display
(recommended: bottom edge of the device approx. 1.35 m above floor level).
The two screws must be level.
The charging station must be secure after it is attached.
124 mm
Fig. 2
Charging station as a wall support
Plug the connector of the external power supply unit into the socket on the
bottom of the charging station
Plug the external power supply unit into a power socket.
The charging station is now ready for operation.
Commissioning