890405_d•en•2015-12-01
We reserve the right to carry out improvements
12
WMS Central transmitter
3 Commissioning
The WMS Central transmitter is ready for operation after only a few steps.
Films on commissioning can be found at:
http://www.warema.de/inbetriebnahme-funksysteme
NOTE
We recommend commissioning using the WMS studio PC software.
3.1 Scope of delivery
The box contains the following parts:
WMS Central transmitter
Charging station (two parts). With the separate base, the station can be used
on a table or as a wall support.
External power supply unit for charging station (100 to 240 V AC, for use
worldwide)
Microfibre cloth for gentle cleaning of the acrylic glass surface
Two screws and two dowels for mounting the charging station on the wall, if
desired
3.2 Charging station
To operate the WMS Central transmitter, you can hold it in your hand or leave
it in the charging station. The charging station can be used on a table or as
a wall support.
CAAUIOA
The WMS Central transmitter and charging station are for indoor use only. Do
not erect or install the products outdoors.
3.2.1 Charging station as a
table stand
If you wish to use the charging station as a table stand, connect the two
parts of the charging station as shown until they engage.
Fig. 1
Charging station as a table stand
Plug the connector of the external power supply unit into the socket on the
bottom of the charging station
Pass the cable through the two slots to the back of the charging station.
Observe the following points when erecting the unit:
Commissioning