Wallenstein WP240, Operator'S Manual

Page: 34 / 60

• Review and follow the Pre-Operation Checklist
(see page 25).
• Review operation and function of the Controls (see
page 26).
•
Survey the work site, move to a clear, level work
area and position at the work site. Do not start the
Wood Processor until it is in position.
• Set up the machine (see page 35).
• Wear appropriate Personal Protective
Equipment whenever operating the Wood
Processor or working in the vicinity.
5.2 Starting
1. Move all controls to neutral or off position.
2. Move the throttle to its 1/4 throttle position.
3. Start tractor engine.
4. Run the engine for a few minutes to allow it to
warm.
5.
Reduce engine RPM to low idle.
6. Engage PTO or place hydraulic circuit lever in
detent.
7. Increase throttle setting to maximum speed for
operation.
8.
Move to the operator's station to proceed with the
work.
9. Start attaching logs to the winch.
5.3 Stopping
1. Stop winching, cutting or splitting logs.
2.
Slow engine RPM.
3. Disengage PTO control or move hydraulic lever out
of detent into its off position.
4. Stop engine using ignition switch.
5.4 Emergency Stopping
If an emergency occurs:
1. Shut off the engine.
2. Set all hydraulic controls to neutral.
Correct emergency situation before restarting engine
and resuming work.
Operation
WP240-WP270
3-Point Hitch Firewood Processor
34