Wallenstein WP240, Operator'S Manual, Page: 35 / 60

5.5 Machine Set-Up
Follow this procedure to prepare and set-up the
machine at the work site:
CAUTION!
Position the machine so any wind blows the
exhaust gases and fumes away from the
operator's station.
1. Use the tractor to position the machine at the work
site.
2. Remove the snapper pins securing the bracing
jacks and turn them up to the bracing position.
3. Replace the snapper pins to secure the jacks.
NOTE:
Angle the jacks upward so they will
contact the ground evenly when the chute
is lowered.
4. Remove the latch pin that holds the chute lock arm
to the log loader chute.
5. Pull the lock arm away from the chute and swing
it down. Secure it to the side of the frame with the
latch pin.
Secure Latch
Clamp
Secure Snapper
Pin on Brace
Jacks
Secure Latch
Pins on Chute
Lock Arm
Z94242
Caution:
When lowering the
chutes, be aware of pinch
points.
Release Log
Loader Chute
Lock Arm
Z94403
Fig. 21 – Machine Set Up
3
4
5
6
2
7
8
9
10
9
WP240-WP270
3-Point Hitch Firewood Processor
Operation
35