Wallenstein WP240, Operator'S Manual

Page: 31 / 60

4.7.2 Tractor Hydraulics
Connect the Hydraulic System:
1. Use a clean cloth or paper towel to clean the dirt
and build-up from around the couplers and the
male tips.
2. Connect the hoses to the tractor couplers. Be sure
the couplers are securely seated.
3. Route and secure hoses along the hitch with clips,
tape or plastic ties to prevent binding and pinching.
4. Remove the top pin and install the top link. Use the
turnbuckle to align the top link. Insert the pins and
install the retainers. Return the turnbuckle to its
original length and lock.
5. Slowly raise the machine through its working
range to make sure the hydraulic components and
linkages don't bottom out.
6. Level the machine front and rear, and side to
side using the jackscrew on the right arm and the
turnbuckle on the top link.
7. To unhook from the tractor, reverse the above
procedure. Always park the machine in a dry, level
area.
Fig. 18 – Leveling adjustments
Fig. 16 – Second hydraulic circuit
Fig. 15 – First hydraulic circuit
Fig. 17 – Top link
WARNING!
Always use caution when working with high
pressure hydraulics.
WP240-WP270
3-Point Hitch Firewood Processor
Controls
31