Wallenstein WP240, Operator'S Manual

Page: 32 / 60

Fig. 19 – Gear box
Fig. 20 –
Anchor chain
4.7.3 Power Pack Hydraulics
Ensure the Power Pack is correctly installed and
plumbed on the Wood Processor. To install the Power
Pack, follow the installation instructions supplied with
the unit.
Connect the Hydraulic System
For units with the optional Power Pack, install the
gear box on the tractor shaft:
1. Align the splines and slide the gear box on the
tractor shaft.
NOTE: Be sure the shaft is clean and free of dirt.
2. Attach the anchor chain to an adjacent frame
component to prevent the gear box from turning
and hold the assembly on the shaft.
3. Route and secure hoses along the hitch with clips,
tape or plastic ties to prevent binding and pinching.
4. Remove the top pin and install the top link. Use the
turnbuckle to align the top link. Insert the pins and
install the retainers. Return the turnbuckle to its
original length and lock.
5. Slowly raise the machine through its working
range to make sure the hydraulic components and
linkages don't bottom out.
6.
Level the machine front and rear, and side to
side using the jackscrew on the right arm and the
turnbuckle on the top link.
7. To unhook from the tractor, reverse the above
procedure. Always park the machine in a dry, level
area.
WARNING!
Always use caution when working with high
pressure hydraulics.
Controls
WP240-WP270
3-Point Hitch Firewood Processor
32