Wacker Neuson RTLx-SC3, Operator'S Manual

Page: 37 / 186

Operation
SmartControl™ SC-3 Transmitter 6.7
37
[en-US] | 09/2022 | 5100061327 | RTLx-SC3 | Operator’s Manual
Ref Component Description
1 Cable connector The cable connector provides a connection point for the transmitter cord. When the
transmitter cord is connected, the transmitter battery recharges while the engine is
running.
2 Infrared emitting
diodes The diodes—located on all sides of the transmitter—are used to transmit the coded
infrared signal to the receiving eyes on the machine.
Keep the transmitter clean to ensure maximum signal strength.
3
7
Forward/reverse
(travel) joystick
Left/right (steering)
joystick
The right joystick (3) controls forward/reverse motion.
The left joystick (7) controls left/right motion.
Move the joysticks in the direction desired. The roller will change to high speed when-
ever the travel joystick is placed fully in the forward or fully in the reverse position.
4 Battery charge indi-
cator This LED illuminates green while the battery is charging.
5 Near field transmit-
ting diodes (LEDs) These LEDs—located on all sides of the transmitter—are part of the machine’s sens-
ing system which stops the machine when the operator and transmitter are located
too close to the machine.
6 Operating status in-
dicator This LED indicates the operating status of the transmitter.
For further information, see Operating Status Indicator Codes [ } 38] .
8 Engine START push-
button Pressing this button causes the engine to crank. An override prevents the engine from
cranking if it is already running.
9 ON-OFF pushbutton Pressing this button turns on and off the SmartControl™ transmitter. The operating
status indicator (6) illuminates green (flashing) when the transmitter is on.
Turning the transmitter off stops the engine and the machine. For further information,
see
Emergency Shutdown Procedure [
}
53] .
10 LOW vibration push-
button Pressing this button causes the vibration to come on in the LOW vibration mode.
11 Vibration OFF push-
button Pressing this button causes all vibration to stop.
12 HIGH vibration push-
button Pressing this button causes the vibration to come on in the HIGH vibration mode.
— Vibration pushbut-
tons When the machine is moving in the high speed travel mode, pressing either vibration
pushbutton
(10) or (12) causes the roller to drop out of the high speed travel mode
and into the low speed travel mode. Conversely, when the vibration is on, the ma-
chine cannot go into the high speed travel mode.
13 Signal transmission
indicator To aid in diagnostics, this green LED flashes any time a signal is sent to the roller.
14 Control channel se-
lector switch This selector switch, when set to match that of the machine’s decoder module, allows
the SmartControl to control the roller.
6