Wacker Neuson ET35, Operator'S Manual

Page: 108 / 302

4-44
BA E16 en* 1.0 * E16_10_400.fm
4 Putting into operation
1. Move vehicle Y close to machine X so that the length of the battery
jumper cables is sufficient.
2. Stop the engine of vehicle Y .
3. Engine covers of both vehicles are open.
4. Remove the red cover
E .
5. Connect the battery jumper cables in the following order: A – B – C –
D .
6. Start the engine of vehicle Y .
7. Wait five minutes for the empty battery to be charged a little.
8. Start the engine of machine
X .
9. Switch on the boom light of vehicle X in order to avoid voltage peaks
and to protect the electronic system.
10.Disconnect the battery jumper cables in the following sequence: D – C
– B – A .
Fig. 117
B
C
_
+
A
D
Designations/symbols Meaning
X Machine with empty battery
Y Vehicle with full battery
A Positive/vehicle X
B Positive/vehicle Y
C Negative/vehicle Y
D Negative/vehicle X
Full battery
Dead battery
Fig. 118
A
E
Fig. 119
D