EP 424 End Prep Machine
60
Part No. 81-MAN-00, Rev. 0-0610
E.H. Wachs
6.
Turn the feed handle clockwise until the drawbar nut
emerges from the back of the machine.
Figure 5-46. Engage the mandrel threads fully in the
feed nut for stable operation.
7.
Using a 3/16” hex wrench, loosen the tooling set
screws in the tool holder and put the tool in the holder.
Tighten the set screws.
Figure 5-47. Insert the tool in the tool holder and
tighten the set screws holding it. Make sure the cutting
edge of the tool is toward the direction of rotation, as
shown.
8.
Install any other tools required for the operation in the
other tool holders. You can perform up to 3 operations
Direction of
rotation
Summary of Contents for EP 424
