Wachs EP 424, User Manual

Page: 53 / 122

Chapter 5, Operating Instructions: Using the Drive Motors
E.H. Wachs Part No. 81-MAN-00, Rev. 0-0610 49
Figure 5-29. Squeeze the air motor trigger to start the
machine.
6.
Adjust the motor speed by turning the speed control-
ler.
Figure 5-30. Turn the speed control collar to adjust
the rotation speed of the machine.
The use of coolant or cutting
lubricant is recommended.
This will improve the cutting
performance and increase
the life of the tooling.
7.
While holding the air motor trigger, operate the
machine as described in the appropriate section below
(form tool or single-point operation).
8.
As the machine cuts, adjust the air motor speed if nec-
essary to reduce chatter and achieve the appropriate
end prep finish.
9.
When the prep is complete, release the air motor trig-
ger to stop the machine.
NOTE