Wachs EP 424, User Manual

Page: 60 / 122

EP 424 End Prep Machine
56 Part No. 81-MAN-00, Rev. 0-0610 E.H. Wachs
Figure 5-40. The chart describes the tooling used for
J-prep operations.
Adjusting the Tool Holder Positions
You may need to change the positions of the tool holders in
the rotating head, depending on the pipe diameter. Each tool
holder can be set to an “inner” (small diameter) or “outer”
(large diameter) position.
1.
Using a 1/4” hex wrench, remove the 8 screws holding
the tool holder to the rotating head. (Note: if the tool
holder is already in the outer position, it will have 6
screws holding it.)