FLASHBAKE
®
/ MICROWAVE OVEN REMOVAL AND REPLACEMENT OF PARTS
Form 24694 (April 2001)
Page 17 of 52
MODEL FBMW2 SHOWN
MODEL FBMW2 SHOWN
MODEL FBMW3 SHOWN
6.
Squeeze tabs and push vent fan motor
connector out of duct.
NOTE: Cut cable ties as needed to access wiring.
Replace wire ties when work is complete.
7.
For Model FBMW2:
A.
Disconnect wires from vent fan motor
capacitor.
B.
Disconnect wires from fuse.
C.
Disconnect wires from high voltage
capacitor.
D.
Work high voltage capacitor wires out of
wire retainer on duct.
E.
Pass connector and wires down through
hole.
8.
For Model FBMW3:
A.
Disconnect wires from vent fan motor
capacitor.
B.
Remove “NOISE FILTER BOARD.”
C.
Disconnect wires from high voltage
capacitor.
D.
Work high voltage capacitor wires out of
wire retainer on duct.
E.
Pass connector and wires down through
hole.
9.
Remove screws (13 screws) securing assembly
to top of unit.
NOTE: Screw lengths differ in certain locations.
Identify screws for installation later.
A.
Five screws in right duct.
