FLASHBAKE
®
/ MICROWAVE OVEN REMOVAL AND REPLACEMENT OF PARTS
Form 24694 (April 2001)
Page 24 of 52
TURNTABLE MOTOR
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1.
Remove "BOTTOM PANEL.”
2.
Disconnect wires from motor.
3.
Remove two screws securing motor and plate
to oven.
4.
Remove motor and plate as an assembly and
watch for ceramic shaft. Shaft may come out
with assembly or fall out when assembly is
removed.
5.
During reassembly washer must be installed to
prevent microwave energy leakage.
6.
Installation is easier if motor, plate and ceramic
shaft are assembled and then placed on oven.
7.
Reverse procedure to install.
THERMAL CUT OUTS
Cavity, Top Left
NOTE: This thermal cut out is nonresetable. When
replacing be sure to determine cause of failure.
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1.
Remove "MAIN COVER.”
2.
Remove four screws securing left plastic air
duct.
3.
Disconnect wires from thermal cut out.
