FLASHBAKE
®
/ MICROWAVE OVEN REMOVAL AND REPLACEMENT OF PARTS
Form 24694 (April 2001)
Page 18 of 52
B.
Four screws in left duct.
NOTE: Anytime left duct is removed or lifted, clean
perforated area underneath duct.
C.
Four screws in center metal duct.
10. Perform steps 2 thru 5 in removing "CONTROL
PANEL.”
11. Unplug connectors as required so assembly
can be lifted off unit.
12. Reverse procedure to install.
UPPER LAMP ASSEMBLY
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1.
Remove "UPPER LAMP HOUSING AND
DUCT ASSEMBLY.”
2.
Remove lamp housing by straightening two
tabs on each side and then separating it from
the duct assembly.
3.
Work lamp wires out of wire retainers and
disconnect wires from thermal cut outs.
CAUTION: Use clean dry cloth to handle lamps.
DO NOT get finger prints or any other residue
on lamps because the lamp life will be
shortened. Clean cold lamps with a cloth
moistened with alcohol cleaner to remove skin
oil or other residue.
4.
Reverse procedure to install.
