Vortice VORT VDH 60 HP MONO, Instruction Booklet

Page: 50 / 136

50
Electrical connections
Fig. 41
Equipment must be powered by means of an external electrical mains. Installation of the electrical system can be carried
out with a trace system (built-in) or surface mounted by means of external wall cable.
Fig. 42
If you should decide to set up a trace system conductor at the back, you need to pass the power cable, having about ten
centimetres of cable protrude.
Fig. 43
Connect the cable conductors to the female triple connector supplied with the equipment.
Warning!:
If you decide to insert the power cable from below and not from the back, the connector needs to be connected later,
or rather after you have passed the cable from the input located at the bottom of the equipment.
!
41 41
Cable entry
from below
Cable entry
from wall
42 42
~ 10
cm
43 43
N
L
230V ~50Hz
PE
MAINS
Connettore tre
poli femmina
L
PE
N
ENGLISH
CAUTION!:
Equipment connection must be carried out by professionally qualified personnel.
!
CAUTION!:
The electrical power line to which the equipment will be connected must be protected by a suitable differential
thermal magnetic switch.
!