60
3-6 Loop Protection
3-6.1 Configuration
The loop Protection is used to detect the presence of traffic. When switch receives packet’s
(looping detection frame) MAC address the same as oneself from port, show Loop Protection
happens. The port will be locked when it received the looping Protection frames. If you want to
resume the locked port, please find out the looping path and take off the looping path, then
select the resume the locked port and click on “Resume” to turn on the locked ports.
Web Interface
To configure the Loop Protection parameters in the web interface:
1.
Click Port Management, Loop Protection and Configuration.
2.
Evoke to select enable or disable the port loop Protection.
3.
Click the apply to save the setting.
4.
If you want to cancel the setting then you need to click the Reset button. It will revert to
previously saved values.
Figure 3-6.1: The Loop Protection Configuration
Parameter description :
Global Configuration
Enable Loop Protection :
Controls whether loop protections is enabled (as a whole).
Transmission Time :
The interval between each loop protection PDU sent on each port. Valid values are 1 to 10
seconds.
Shutdown Time :
Summary of Contents for VivoCam AW-GEV-104B-130
Page 13: ...6 Figure 1 The login page ...
Page 25: ...18 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 52: ...45 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 136: ...129 Reset Click to undo any changes made locally and revert to previously saved values ...
