142
11-2 Cable Diagnostics
This section is used for running the VeriPHY Cable Diagnostics. Press to run the diagnostics.
This will take approximately 5 seconds. If all ports are selected, this can take approximately 15
seconds. When completed, the page refreshes automatically, and you can view the cable
diagnostics results in the cable status table. Note that VeriPHY is only accurate for cables of
length 7 -140 meters.10 and 100 Mbps ports will be linked down while running VeriPHY.
Therefore, running VeriPHY on a 10 or 100 Mbps management port will cause the switch to
stop responding until VeriPHY is complete.
Web Interface
To configure a Cable Diagnostics Configuration in the web interface:
1.
Click Diagnostics and Cable Diagnostics.
2.
Specify Port which you want to check.
3.
Click Start.
Figure 11-2: The
Cable Diagnostics
Parameter description:
Port :
The port where you are requesting Cable Diagnostics.
Cable Status
Port :
Port number.
Pair :
The status of the cable pair.
Length :
The length (in meters) of the cable pair.
Button
Start :
Start to cable diagnostics the port that you selected.
Summary of Contents for VivoCam AW-GEV-104B-130
Page 13: ...6 Figure 1 The login page ...
Page 25: ...18 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 52: ...45 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 136: ...129 Reset Click to undo any changes made locally and revert to previously saved values ...
