120
10-1.2 Access Management
This section shows you to configure access management table of the Switch including
HTTP/HTTPS, SNMP, and TELNET/SSH. You can manage the Switch over an Ethernet LAN, or
over the Internet.
Web Interface
To configure an Access Management Configuration in the web interface:
1.
Click Security,
Management and Access Management.
2.
Select “on” in the Mode of Access Management Configuration.
3.
Click “Add new entry”.
4.
Specify the IP Address, Mask Length.
5.
Checked Access Management method (HTTP/HTTPS, SNMP, and TELNET/SSH) in the
entry.
6.
Click Apply.
Figure 10-1.2: The Access Management Configuration
Parameter description:
Mode :
Indicates the access management mode operation. Possible modes are:
On :
Enable access management mode operation.
Off :
Disable access management mode operation.
VLAN ID :
Indicates the VLAN ID for the access management entry.
Delete :
Check to delete the entry. It will be deleted during the next save.
IP address :
Enter the source IP address.
Mask Length :
Enter the Mask Length.
HTTP/HTTPS :
Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP
Summary of Contents for VivoCam AW-GEV-104B-130
Page 13: ...6 Figure 1 The login page ...
Page 25: ...18 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 52: ...45 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 136: ...129 Reset Click to undo any changes made locally and revert to previously saved values ...
