19
2-4 Log
2-4.1 Syslog Configuration
The Syslog Configuration is a standard for logging program messages . It allows separation of
the software that generates messages from the system that stores them and the software that
reports and analyzes them. It can be used as well a generalized informational, analysis and
debugging messages. It is supported by a wide variety of devices and receivers across multiple
platforms.
Web Interface
To configure
Syslog Configuration
in the web interface:
1.
Click System, Log and
Syslog Configuration
.
2.
Specify the syslog parameters include IP Address of Syslog server and Port number.
3.
Evoke the Syslog to enable it.
4.
Click Apply.
Figure 2-4.1: The System Log configuration
Parameter description:
Mode :
Indicate the server mode operation. When the mode operation is enabled, the syslog
message will send out to syslog server. The syslog protocol is based on UDP communication
and received on UDP port 514 and the syslog server will not send acknowledgments back
sender since UDP is a connectionless protocol and it does not provide acknowledgments.
The syslog packet will always send out even if the syslog server does not exist. Possible
modes are:
On: Enable server mode operation.
Off: Disable server mode operation.
Server 1 to 6 :
Indicates the IPv4 hosts address of syslog server. If the switch provide DNS feature, it also
can be a host name.
Buttons
Apply :
Summary of Contents for VivoCam AW-GEV-104B-130
Page 13: ...6 Figure 1 The login page ...
Page 25: ...18 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 52: ...45 Reset Click to undo any changes made locally and revert to previously saved values ...
Page 136: ...129 Reset Click to undo any changes made locally and revert to previously saved values ...
