Vitek VT-SRE Spire Elite, User Manual

Page: 85 / 150

85
Email
if an event occurs, this will notify registered users of the event by email. if you do not want to receive the email, uncheck
the <EMAiL nOTiFy> option in <MAnAgEMEnT>. (Page 41)
i
ADD nEW EMAiL
if you want to add a new mail recipient beside the
existing ones, click this to add the recipient.
i
MiniMUM EMAiL FREQUEnCy
Adjust the minimum frequency of sending emails.
For example, even if you have set the minimum
frequency to one minute and another event occurs
less than one minute after the last email was sent,
the email for the new event will be sent one minute
after.
Some email servers can block this feature if the
email delivery cycle is too short, and classify it as
spam.
Contact your email service provider to adjust the
minimum delivery cycle so that the server does not classify the email as spam.
\ \
Alarm Sensor
you can configure the settings of the alarm sensor and specify the operation if an event occurs.
1.
From <MEnU> - <SySTEM SETUP> - <EVEnT>, select
<ALARM SEnSOR>.
2.
Use the [
▲▼◀▶
] buttons on the remote control or use the
mouse to specify the sensor input method and operation.
i
nAME : you can specify the name of the alarm
sensor.
i
OPERATiOn : you can specify the type of the alarm
sensor.
-
n/O (normal Open) : normally the sensor is left
Open. if the sensor switches to Close, an event
will be triggered.
-
n/C (normal Close) : normally the sensor is left
Close. if the sensor switches to Open, an event will be triggered.
i
LinKED CAMERA : Set the camera to sync with the alarm sensor if it is triggered.
if you have programmed the alarm recording and the sensor triggered, all synchronized cameras will start alarm
recording.
i
ALARM OUTPUT : Specify the alarm output channel
i
BUZZER : Enables the buzzer if an alarm is detected by the alarm sensor.
i
PRESET: Directs connected PTZ cameras to specified existing presets.
i
ViDEO POPUP : Enables the video popup if an alarm is detected by the alarm sensor.
if there exist multiple <LinKED CAMERA>, the video popup will be displayed in the maximum split mode.
i
OSD POPUP : Enables an OSD popup message if it is detected by the alarm sensor.
i
EMAiL : Select to send an email if detected by the alarm sensor.
3.
To apply the change, click <APPLy> in the bottom of the screen.
4.
When done, press the [ExiT] button on the remote control or click <CLOSE> in the lower screen. The confirmation
message appears and you will return to the previous menu.
System Setting