Vitek VT-SRE Spire Elite, User Manual

Page: 29 / 150

29
VT
-SRE Installation
Connecting to an external device
\ \
Connecting to the monitor
This product supports 1080p 60 Hz HDMi monitors and regular monitors that support DVi and VgA inputs. Connect an
HDMi cable to the port on the product’s rear bottom, or connect an HDMi-DVi converter cable to connect a DVi monitor.
Or, use VgA cable to connect the product with a VgA monitor.
• Once the product is set for nTSC or PAL output, connect cameras of the corresponding video
standard for proper operations.
Setting the product to nTSC or PAL decides available display output modes too.
if set to PAL, the monitor must be able to display at 50Hz. For nTSC setting, it
displays at 60 Hz.
\ \
Power Connection
Plug the provided DC 12V adaptor in the rear power port of the DVR.
•
For stable operation of the product, it is recommended to use the provided adapter. (12V, 5A)
•
Make connection when the power is not applied yet.
•
Arrange up the cables and be careful not to peel off the cable coating.
•
Do not place the power cord under the carpet or rug. The power cord is usually earth-grounded.
However, even if it's not earth-grounded, do never modify it on your own for earth-grounding.
•
Do not insert multiple devices in a single power socket. Otherwise, it may cause a power overload.
•
For stable power supply, this product provides two separate adaptors and two corresponding AC
cords by factory default. Make sure all cables are connected properly.
HD-MONITOR
VGA
eSATA USB LAN(DOWNLINK)
RS232
RELAY
ALARM
485+ 485- GNDGND
NC2
GND IN2 IN3 COM1 NO1 COM2
GND 232TX 232RX IN0 IN1
RS485
SPOT OUT
P
A
L
N
T
S
C
DC 12V
HD MONITOR eSATA USB LAN(DOWNLINK)
WAN(UPLINK)
VIDEO IN
RS-232
RELAY ALARM IN
485+ 485- GNDGND
NC2
GND IN3 IN4 COM1 NO1 COM2 GND 232TX 232RX IN1 IN2
RS-485
AUDIO
OUT
AUX
SPOT OUT
AUDIO
IN 1
AUDIO
IN 2
AUDIO
IN 3
AUDIO
IN 4
AUDIO IN
15
16
13
14
11
12
9
10
7
8
5
6
3
4
1
2
P
A
L
N
T
S
C
VGA
DC 12V
DC 12V adaptor