9 Services
9.4.2.3. Client Settings
In this section you can make the necessary settings for each Client.
9.4.2.3.1. Client LAN IPv4-Address It is the local network IP address of the Client. This adress
should be from the IPv4 address ranges assigned to private networks. The table
on section
shows the reserved private IPv4 addresses.
Figure 79: SimpleVPN - Client LAN IPv4-Address
By default it is the best option to use private adresses from the class C block. If you need more
than 65,536 Hosts you can use one of the other classes. Please use not the two IPv4 addresses which
are used to connect the encrypted VPN tunnel, also do not use addresses of the 10.8.0.0/24 range.
The gure
shows the dierence between public and private IP addresses.
9.4.2.3.2. Client LAN IPv4-Netmask Please choose the corresponding netmask for the private
IPv4 address. A netmask is a 32-bit mask used to divide an IP address into subnets and specify
the networks available hosts.
Figure 80: SimpleVPN - Client LAN Netmask
The table
in section
shows common netmasks.
9.4.2.3.3. Upload Client Certicates and Keys You will need the following certicates and keys
for each client:
Client certicate
Client private key
Click on the button [Browse] and select the le to upload a certicate or a key. One can also
generate these keys and certicates on the device itself at bottom of the page.
Juli 2016
VPNRouter Software Manual
65
