Vinpower ROBOTIC AUTOLOADER 3.5, User Manual

Page: 37 / 53

Page 33
Setup
12. CD Overburn
CD Overburn
ON
CD Overburn
OFF
Max Failure per Job
[030] OK?
Setup
13. Max Failure per Job
11.12 Overburn
Overburn is a burning method to bypass the capacity limitations of the media to burn further out onto the
edge of the media. This can result in slightly higher storage capacity; however, it has also been known to
have compatibility playback issues. Please use it with caution.
Note: This works only for CD and BD media. Due to physical limitations of the DVD media, it is not
possible to record more than the advertised capacity.
Use the
Up or Down button to select the 12. CD Overburn menu and
press the ENT/Enter button to enter that menu.
Use the Up or Down button to select whether the CD Overburn
feature is ON or OFF, and press the ENT/Enter button to select that option.
11.13 Max Failure per Job
Use this setting to set the maximum failures the autoloader is allowed per job. Once the maximum is
reached, the job will be stopped. The default value for this setting is 30.
Use the
Up or Down button to select the 13. Max Failure per Job
menu and press the ENT/Enter button to enter that menu.
You can select numbers between 1 to 999 by pressing the
Up or Down button:
To specify the number of maximum failures per job, you need to
enter/input a three-digit number.
If you need to specify a number that is less than three digits, fill the leading spaces with zeros (any leading
zeros will be skipped). Examples of three-
digit numbers are “034” (thirty four), or “010” (ten).
To enter the number, you need to use the Up or Down button to select the number for each digit and
use the ENT/Enter button or the ESC/Escape button to move the cursor position right or left. Once you've
finished, move the cursor to “OK” and press the
ENT/Enter button. For example, if you want to specify a
counter value of 21 (twenty one). The three-
digit value would be “021.” To input the desired quantity, do the
following:
Make sure the cursor is located at the first position (First blinking position):

Press the Down
button repeatedly until “0” is displayed.

Press ENT/Enter button once to move the cursor to the next position.

Press the Down
button repeatedly until “2” is displayed.

Press ENT/Enter button once to move the cursor to the next position.

Press the Down
button repeatedly until “1” is displayed.
 Now, “021” is displayed, press
ENT/Enter
button once and the cursor moves to “OK”.
Then, press the
ENT/Enter button once to submit your maximum failures per job.