47
© 2012 Viking Preferred Service
Service Diagnostics and procedures–Disassembly
evaporator Cover
1. Remove freezer drawer, baskets, and glide
adapters (see Freezer Drawer, Baskets, Bins
Glides and Glide Adapters section,
pages 39-42).
2. Remove freezer thermistor cover (see Freezer
Thermistor section, page 46).
3. Remove evaporator fan cover.
4. Remove securing screws, wiring harness and
evaporator cover.
With the evaporator cover removed, the
evaporator fan, the freezer thermistor, defrost
heater, and defrost thermostat are accessible.
5. Reverse procedure to reinstall.
evaporator Fan
The unit uses a fan motor to pull air over the
evaporator coil and circulate it throughout the unit.
Evaporator Fan access:
1. Remove freezer drawer, baskets, and glide
adapters see Freezer Drawer, Baskets, Bins
Glides and Glide Adapters section,
pages 39-42).
2 Remove evaporator cover (see Evaporator
Cover section at left).
3. Remove securing screws.
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Evaporator
Fan Cover
Screw
Wiring Harness
Screw
