35
© 2012 Viking Preferred Service
Refrigerator Damper:
To access the refrigerator damper:
1. Open doors and remove shelves.
2. Remove louvered cover off of damper control.
3. Remove screws holding housing to rear
wall and remove housing.
3. Disconnect wiring and remove damper.
4. Replace or repair as necessary.
5. Reverse procedure to reinstall.
Water Filter
The unit has a water filter system designed to filter
a flow rate of 0.78GPM and a maximum pressure of
120 PSI.
To access the water filter:
1. Open door(s), depress filter cover release, and
lower filter cover.
2. Remove filter by turning counterclockwise.
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Louvered Cover
Screw
Wiring Harness
Water Filter
Filter Cover
Service Diagnostics and procedures–Disassembly
