Viking GE 355, Instruction Manual

Page: 50 / 545

0478 201 9907 D - EN 48
●
Attach feed chute (1) to fastening hooks
on basic unit (2) and pivot forwards.
●
Screw in closure screws (3) and
tighten.
11
.4 Removing the feed chute
●
Unscrew and remove closure
screws (1).
●
Pivot the feed chute (2) to the rear and
remove.
11
.5 Removing the blade set
1
Lock the blade disc
●
Remove the feed chute. (
Ö
11.4)
●
Turn the blade disc (1) to the position
shown and fold the locking device (2)
upwards as far as it goes.
2
Detach blade set
●
Loosen screw (3) using installation
tool (U) and unscrew completely.
●
Remove screw (3), lock washer (4) and
clamping ring (5).
3
Remove the wing blades
●
Remove wing blade (6), wing blade (7)
and wing blade (8).
4
Remove the blade disc
●
Fold back locking device (2).
●
Remove blade disc (1).
11
.6 Installing the blade set
1
Fit the blade disc
●
Fit blade disc (1) onto the blade
mounting. When doing so, pay attention
to the teeth on the blade mounting.
2
Fasten the blade set
●
Turn blade disc (1) to the position
shown and fold locking device (2)
upwards as far as it goes.
3
Fit the wing blades
●
Fit wing blade (4), wing blade (5) and
wing blade (6).
4
Fasten the blade set
●
Fit clamping ring (7) and fasten
together with retaining washer (8) and
screw (9).
●
Tighten the screw (9) using the
installation tool (U) (
45 - 50 Nm ).
●
Fold back locking device (2) again.
●
Install the feed chute. (
Ö
11.3)
11
.7 Blade set service intervals
Maintenance interval:
Before each use
Check the blade set (consisting of blade
disc, shredding blades, retaining washer,
clamping ring and screw) for wear, firm
seating, cracks or other damage.
11
.8 Electric motor and wheels
The electric motor is maintenance-free.
The wheel bearings are maintenance-free.
Following assembly, check by
visual inspection that the feed chute
is correctly engaged in the
fastening hooks.
Risk of injury:
Always disconnect the mains plug
before removing the closure
screws. Always wear thick gloves.
Risk of injury:
Always wear gloves.
Do not touch the blades
until they have come to a
standstill.
1
7
1
8
Risk of injury:
Always wear gloves.
Before attaching the
blade set, visually check
that the blade disc and all
shredding blades are OK and have
no notches, cracks or pieces
chipped out.
Clean the blade mounting on the
machine, the blade disc and the
shredding blade before attaching
the blade set.
The blade disc including the
chipping blade and the three wing
blades are equipped with a toothed
blade mounting. This prevents
incorrect installation of the entire
cutting unit, as the blades can only
be attached to the blade mounting
when in the correct position.
1
9
The numbers (3) on the inside of
the wing blades refer to their
installation sequence.