Page | 4
Section 2: Compliances and Safety Statements
2.0 FCC Class A
This equipment has been tested and found to comply with the limits for a
Class A computing device pursuant to Subpart J of part 15 of FCC
Rules, which are designed to provide reasonable protection against such
interference when operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference
in which case, the user will be required to correct the interference at the
user’s own expense.
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
You may use unshielded twisted-pair (UTP) for RJ45 connections –
Category 3 or better for 10 Mbps connections, Category 5 or better for
100 Mbps connections, Category 5, 5e, or 6 for 1000 Mbps connections.
For fiber optic connections, you may use 50/125 or 62.5/125 micron
multimode fiber or 9/125 micron single-mode fiber.
Coax cables should standard RG59 with resistance values near or close
to 22K ohms. Aluminum shielded cable cannot be used.
2.1 FCC Caution
To assure continued compliance (example: use only shielded interface
cables when connection to computer or peripheral devices), any changes
or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Coax cables should standard RG59 with resistance values near or close
to 22K ohms. Aluminum shielded cable cannot be used.
2.2 CE Mark
Warning
This is a Class A device. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
Summary of Contents for MaxiiNet Vi32226
