Page | 24
5.8 Installing an
SFP Transceiver
Step 1.
Consider network and cabling requirements to select an
appropriate SFP transceiver type.
Step 2.
Insert the transceiver with the optical connector facing outward
and the slot connector facing down. Note that the SFP transceivers are
keyed so they can only be installed in one orientation.
Step 3.
Slide the SFP transceiver into the slot until it clicks into place.
NOTE:
SFP transceivers are not provided in the switch
package.
5.9 Connecting to
a Power Source
You can plug or remove power cord from AC power socket to switch the
power on or off.
Figure 13: Inserting the Power Cord to AC Power Socket
Step 1.
Insert the power cable plug directly into the AC Socket located at
the back of the switch.
Step 2.
Plug the other end of the cable into a grounded, 3-Pin, AC power
source.
Step 3.
Check the front-panel LEDs as the device is powered on to be
sure the POWER LED is lit. If not, check that the power cable is correctly
plugged in.
WARNING:
For International use, you may need to change
the AC line cord. You must use a line cord set that has been
approved for the socket type in your country.
Summary of Contents for MaxiiNet Vi32226
