Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
6-8
P1.1.2-1.1.3
Disable all points in range
Press OK to confirm
or CANCEL
Fig 6-12 – Disable Point Range Confirmation Display
Press
OK
to carry out the function or press
CANCEL
to abort the
command and return to the previous display.
On Enabling a range of points the following choice is given:
P1.1.2-1.1.3 | ALL
|
F1 enables all in range |
F4 enables normal in range | NORMAL
Fig 6-13 – Enable Point Range Choice Display
Pressing:
-
ALL
F1
will enable all points in the range irrespective of their
status (e.g., points could be in alarm).
-
NORMAL
F4
will enable only those points in the range that are in
the Normal condition (i.e., points in alarm, fault, test, etc., will
remain disabled).
Press
OK
in the following confirmation screen to carry out the selected
point enables.
From the Recall Zone Status display, press
MENU
or
MENU
F4
to
display the zone commands.
To jump to a specific zone, press
ENTER
F1
from the Recall Zone
Status display and enter the required zone number - for example,
Zone 23. This would be entered as
2
3
OK
.
Press
MENU
F4
, then
DISABLE
F2
or
DISABLE
to disable the zone.
If the zone is already disabled, the F2 option will be
ENABLE
instead of
DISABLE
. In the confirmation display, press
OK
to confirm or
CANCEL
to abort the command.
Disabling or
Enabling a
Zone from
Recall Display
