Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
12-14
Point Number Point Text Description
241.32.9
I-HUB -
Message
Discard
Indicates fault if the I-HUB has discarded a message after not
receiving confirmation of reception from the remote device
despite multiple retries. This can be caused by a fault or failure of
the device connected at the remote end, wiring faults,
overloading, or noise. The port number that the fault has occurred
on is indicated in a MX1 system event.
241.32.10
I-HUB -
Queue
Overflow
Indicates fault if the I-HUB has had a queue overflow and
message(s) have consequently been lost. This could be due to a
wiring fault, device failure, noise, or other network performance
problems. The port number that the fault has occurred on is
indicated in a
MX1
system event.
241.32.11
I-HUB -
Queue
Warning
Has an active status if the I-HUB has had a queue exceed the
configured queue warning level. This could be due to a wiring
fault, or other network performance problems. The port number
that the warning has occurred on is indicated in a system event.
241.32.12
I-HUB -
Generic Fault
Indicates fault if the I-HUB has a generic fault. This is for use with
future versions of the I-HUB firmware
– connect to the I-HUB’s
diagnostic port for more information.
241.32.13
I-HUB -
Generic
Warning
Has an active status if the I-HUB has a generic warning. This is
for use with future versions of the I-HUB firmware
– connect to
the I-
HUB’s diagnostic port for more information.
241.33.0
PIB Panel
Connection
Provides status of the
MX1
connection to the PIB. Fault indicates
that communication is not possible
– usually because the wrong
serial port is used, the connection is broken, the PIB is turned off,
or a non PIB device is connected. This will also indicate fault
when a PIB with V1.02 or below firmware is connected.
Refer to
NETWORK CONNECTION STATUS
below for
descriptions of the text displayed.
241.33.1
PIB -
Reserved
Unused.
241.33.2
PIB - Remote
PIB
Provides status of remote PIB(s) reported by the local PIB that is
connected directly to the
MX1
.
241.33.3
PIB Ring
Break (FAS1)
Provides the external fault status (usually wired to indicate a ring
break on the IP network) of the local PIB that is connected
directly to the
MX1
.
241.33.4
PIB - Remote
PIB External
Fault (FAS1)
Provides the external fault status (usually wired to indicate a ring
break on the IP network) of remote PIB(s) reported by the local
PIB that is connected directly to the
MX1
.
241.33.5
PIB - PIB
Internal / IP
Connection
Indicates fault if the PIB has an internal fault (e.g. checksum
failure), or the Ethernet / IP connection has failed.
241.33.6
PIB - PIB
PSU
Indicates fault if the PIB has detected a PSU fault (voltage below
minimum).
241.33.7
PIB -
Reserved
Unused.
241.33.8
PIB -
Reserved
Unused.
241.33.9
PIB - PIB
PLink
Message
Discard
Indicates fault if the PIB has had to discard message(s) on the
Panel-Link interface. This could be due to a wiring fault.
241.33.10
PIB - PIB
Queue
Overflow
Indicates fault if the PIB has had a queue overflow. This could be
due to a wiring fault, or other network performance problems.
