28
V2002D-PTZ
User’s Manual
IPv6 default
router address
Manually set a default router address under IPv6
protocol.
Subnet prefix
length
1 ~ 128
Set prefix length for subnet.
IPv6 DNS
Set a DNS (Domain Name Server) under IPv6 protocol.
Wired Setting
Speed & Duplex: Auto/10 or 100 Half Duplex/10 or 100 Full Duplex
To avoid the collision issue, Half Duplex can only send or receive information at one time, while Full
Duplex can receive and transmit in full line rate simultaneously without the issue of collision. For the
Mbps number, the larger the number, the faster the results; the smaller the number, the slower the
results
. “Auto”
allows the camera to decide which mode to use.
UPnP
Enable UPnP: On/Off
When UPnP (Universal Plug &
Play) is “O
n,
”
a device can be detected automatically by any computer
in the LAN to skip the installation of the IP Toolbox utility.
Mode: IP and Device Name/Device Name/User Input
When the camera connects with the LAN, select one of the modes below for identification:
IP and Device Name: The device name and IP address will be shown simultaneously.
Device Name: Only device name will be shown.
User Input: User can input a customized name for the camera.
SSL
Enable SSL: On/Off
Turn Secure Sockets Layer (SSL) on to enable both HTTP and HTTPS communications. Turning SSL
“Off” will allow only HTTP communication. Select the option “Https Only” to enable only HTTPS
communication, which automatically disables web port (port 80).
Note
Before enabling SSL (On/H
ttps Only), refer to “
4.9 SSL
” section to install or generate
SSL certificate
HTTPS Port: (443, 1025~65535)
HTTPS enables a secure video transmission from network camera. It is recommended to use the
default port number 443; however, if it is required to change the port number, contact your system
administrator. This field is only available if SSL has been turned on and configured.
Summary of Contents for Roughneck Pro V2002D-PTZ
Page 98: ......
